LW series centrifuge for separation of detrital material of drilling muds is widely used in solid control system for drilling mud to separate the solids phase of mud, remove harmful fine drill solids such as debris, etc. in the mud fluid, or recover weighting materials such as barite etc. so as to reduce the cost of mud fluid. they are ideal choices for separating particles in drilling mud.
•High Speed up to 3200RPM & Variable Speed by frequency converter
•Solids Liquid separation system package available
•Simplified solid control system, low energy consumption , lighter working load, and the purification efficiency increased by 30% than original
•oilfield Decanting Centrifuge are able to apply over 3,000 G-forces on the liquid/solids mixture, which separates the heavier solids from the lighter solids.
The Centrifuge separate the suspending fluids using the principle of centrifugal action, the suspending fluids is pushed into the rotor drum through the inlet pipe and the fluid hole of the spiral feeder. Under the influence of centrifugal force, solid phase particles are pushed to the internal wall of the drum, then to the nud export of the small end of the drum and excreted. But the fluids is excreted from the overflow hole of the large end. Such cycle is in order to achieve the purpose of continuous separation.
centrifuge also deliver high fluid recovery rates and efficient solids control to significantly reduce the operator’s total mud cost and limit waste disposal volumes.
