①Addressable LED strip,30leds/m,30pcs/m apa102 IC,10mm white/black PCB width,5M/roll,DC5V,7.2W/M,Non-waterproof.
②Addressable LED strip,60leds/m,60pcs/m apa102 IC,10mm white/black PCB width,5M/roll,DC5V,14.4W/M,Non-waterproof.
③Addressable LED strip,144leds/m,144pcs/m apa102 IC,12mm white/black PCB width,1M/roll,DC5V,43.2W/M,Non-waterproof.
Detail use information:
1)Addressable full color led stripsapa102 ic built-in
2)30/60/144pcs led per one meter
3) individually control 1 ic& 1 led chip
4)Standard Reel Length: 5meter/roll(30leds/m,60leds/m), 1meter/roll(144leds/m),also can be customized.
5) Cutted: 1 integrated RGB LEDs per segment, can be cutted per 1LED.you can cut this stuff pretty easily with wire cutters, there are cut-lines
every 0.65''/3.33cm(1 LED each), Solder to the 0.1'' copper pads and you're good to go.
6)Power supply: You must use a 5V DC power supply to power this strip, do not use higher than 6V or you can destroy the entire strip
7)Connectors: 4PIN JST female and male connectors, DAT, CLK, DC5V+, GND-.these LEDs have 2 wires (input and out put) for sending data - one clock pin and one data pin.That means you need two pins, not one, to control DotStars. Because the clock and data is seperated, you can use any processor speed or type to control these strips, and you don't have to worry about being careful with the timing.
8)LED Brightness: Red ~600mcd, Green ~500mcd, Blue ~150mcd
