This is our best sell small simple pellet line for wood biomass and poultry feed pellets production. It is a scientific combination of hammer mill and pellet mill settled on one foundation frame which greatly saves labor and energy consumption.
Introduction of the combine hammer mill and pellet mill
This pellet machine is a scientific combination of hammer mill and pellet mill settled on one foundation frame which greatly saves labor and energy consumption. It is mainly used to process materials less than 50mm like straw, hay, grasses, corn stalk, rice stalk or wood shavings into pellets for fuel or feed use. Just need to put the raw material into this machine directly, and then you can get the qualified pellet. This combine pellet mill and hammer mill can be powered by one electrical motor drive simultaneously. It is ideal equipment for small and medium sized pellets production for personal use or workshop.
Highlight of this combine hammer mill and pellet mill
1.The pellet machine is combined with the hammer mill, and use one motor to drive, thus the consumption of the power is lower than the total power consumption of pellet machine and hammer mill.
2.High efficiency. The processed input material will be transported to the pellet mill directly into the pellet machine, which saves the working time
3.Less land area required. Since the hammer mill and pellet machine are fixed on a same frame, the occupation of the land is highly saved.
4.Most economical machine group, easy operation and maintenance, long life time.
5.Multifunctional, it can be used to produce both biomass pellets and animal pellets.
Operation procedure and tips for Small Homemade Wood Pellet Line
The advantage of this machine is the raw material doesn’t have to crush before processing, you just need put the raw material into this machine directly, and then you can get the feed pellet. The machine can save time, labor and cost.
The hammer mill is used to crush the raw material into powder size prior to entering the pellet mill. The powder is then transported directly to the pellet mill via the Cyclone where dust and raw material is separated and pellets are produced.
It can work better with soft wood and materials with small diameter(less than 50mm).
The material moisture should be about 10 % - 13%, or else you should dry them in the sun before putting them into the wood hammer mill.
