Motorcycle Turn Signal Decoder Indicator LED Load Resistor Flash Fix Error
description
Colour: Black
Quantity: 4
Dimensions: approx. 53 x 9 x 9 mm
Wire length: about 21.5cm
Voltage: DC 12V
10w10ohm / 21W26ohm
The main purpose: some car to install the LED lights will appear after the turn signal will flash, or do not flash the new installation of LED lights and other phenomena. To solve this problem, the installation of this product can solve the turn signal flash and lift the ED lamp failure Alarm, motorcycle suitable.
Installation instructions: turn the lights around the line is not the same, if left and right for the LED lights, left and right to play a product, such as around the lights are changed, you can only install two can, but the left and behind the left Turn the lamp (with a resistor) and the right front and rear right turn signals (with a resistor), use a wire to connect the resistance. For ease of installation, it is recommended that each turn signal is loaded with a resistor
