Product Description:
Limestone, calcite, marble, talcum, barite, gypsum, lime, coarse whiting, attapulgite, dolomite, coal, feldspar, quartz, graphite, coal gangue, fluorite, slag, cement clinker, bauxite, kaolin, cement, activated carbon, petroleum coke, coal ash, iron oxide red etc.
OBM series European technology trapezium mill is the last grinding mill, which absorbing the European advanced technology and many engineers’ ripe experience.
Features:
Low cost, high efficiency.
1) Bevel gear overall drive: the traditional grinding mill is driven by speed reducer and coupling. It is hard to be installed. And there will be too much noisy, and the efficiency is lower. OBM series mill is driven by bevel gear, so its structure is compacter, easy to be installed and more efficient.
2) Inner automatic Thin-Oil lubricating system: the traditional mill adopts grease lubrication, so the lubricating resistance is stronger, the temperature will be higher soon, the bearing life is shorter. OBM series mill adopts inner L.O. pumps, so the main shaft bearing and bevel gear can be lubricated without an additional lubrication system.
Good stability, high reliability
3) Arc air channel: The entire air channel of traditional grinding mill is upright board type. In this case, there will be stronger resistance when the air impacts the air channel board, and the energy of collisions of air molecules loss heavily, as a result, the air channel will be jammed easily because of the eddy air flow. OBM series mill adopts a cambered air channel; the tangential air goes into air channel easily because there is small resistance. And the inner outlet is very good for the grinded material to spread around and avoid grinding material jammed.
4) Cambered shovel with renewable edge: The traditional shove is integral and edge always be worn out quickly, so you have to renew it in short time which affects the working time and wastes too much steel. The shovel edge of OBM series mill adopts high wearable limit alloy, its life will be longer. You only want to change the edge, not the whole shovel. so the steel material is saved. In addition, because the traditional shovel is plane type, the grinded material stacks on the same plane when it is scooped up. So the middle parts of the roller are worn out heavily. But the cambered shovel can scoop up the grinded material in the same vertical plane that makes the rollers and ring worn equally. At the same, the grinding efficiency is higher and capacity is
