PA6 shaft:
Trade names:
Polyamides, PA, Nylon
Color:
Natural White, Black, Green, Others
Length:
1000mm or customized(extruded), 650mm(Cast)
Rods Diameter:
20mm ~ 400mm
Similar plastics:
Acetal, Oil Filled Nylon
The most common engineering nylons are PA6 and PA66. Nylon stock shapes are produced by either extrusion or casting. The process is in part a determinant of the nylon properties of the end product. Modifiers are added to enhance desirable characteristics.
Advantages:
Nylon Rod and Nylon Sheetare tough, durable, general purpose engineering material with special grades for specialty applications. Typical application conditions would be medium speed and temperature in a rugged, abrasive, impact and high load environment.
Disadvantages:
Poor dimension stability, electrical and mechanical properties, may become affected by absorbing moisture or water,acidproof ability not good, can’t dye with acid or touch overmuch acid, weak lightfastness, low endurance in pollution
Key Features:
Excellent bearing properties
High impact strength and toughness
Low power factor requirements
High wear resistance
Very good sliding properties
Applications:
High load bearings
Wear pads
Support and Guide wheels
Conveyor and Tension rollers
Wire rope sheaves
Buffer pads
Gears
Nylon Products:
-Extruded Nylon 6 (PA 6) - natural (white) / black:
Offers an optimal combination of mechanical strength, stiffness, toughness, mechanical damping properties and wear resistance. These properties, together with a favourable electrical insulating ability and a good chemical resistance make extruded nylon 6 a "general purpose" grade for mechanical construction and maintenance.
-MC Nylon 6 (PA 6) - natural (ivory) / black:
Unmodified cast nylon 6 grade exhibiting characteristics which come very close to those of nylon 66. It combines high strength, stiffness and hardness with good creep and wear resistance, heat ageing properties and machinability.
-MC Nylon 6 + oil filled (PA6 + oil) - green:
This internally lubricated cast nylon 6 is self-lubricating in the real meaning of the word. Oil filled MC nylon 6, especially developed for unlubricated, highly loaded and slowly moving parts applications, yields a considerable enlargement of the application possibilities of nylons. This because of its reduced coefficient of friction (up to -50%) and improved wear resistance (up to x 10).
-Nylon 6 + MOS2 (PA6 + MoS²) – grey black:
The addition of
