One Component Automobile Polyurethane Adhesive
PU8630
∎Product Description
PU8630 is one component polyurethane adhesive used in variety bonding and sealing.
∎Key Features
1.No black water flowing after applying sealant (using the low purity shampoo to assist the operation)
2.Low odor, environmental & health
3.Bond very well with surface of variety material such as all kinds of metal, lumber, glass, polyurethane, epoxy, resin, and coating material, etc.
4.One component adhesive with fabulous thixotropy, it’s convenient to apply with rapid curing speed
5.Excellent water, weather and aging resistance
6.Excellent wear-resisting property
7.Paintable and polishable
8.No sag or flow phenomena within 30mm perpends
9.Primerless
∎Typical Applications
1.Specially used for windshield and side glass of bus, car, ship, engineering machinery vehicle, carriage and special vehicle
2.Also use for bonding glass steel and plastic accessories (car roof, side body and car front)
3.Very popular in repair market
∎Technical Data Table
PROPERTY STANDARD/UNITS VALUE
Main raw material Polyurethane
Color Visual inspection Black
Density Gr/cc 1.30±0.05
Sagging mm 0
Extrusion rate ml/min ≥60
Tack free time min 10~30
Curing speed mm/ 24hrs 3~5
Hardness Shore A 61±3
Tensile strength MPa ≥4.5
90
Elongation at break % ≥400
Application temperature °C 5~35
Service temperature °C -40~80
Shelf life month 9
Note：All data above were tested under special condition; storage condition has a direct impact to the products’ shelf life.
∎Directions for Use
Tool: Manual or pneumatic plunger caulking gun
Cleaning: Clean and dry all surfaces by removing foreign matter and contaminants such as oil dust, grease, frost, water, dirt, old sealants and any protective coating.
For cartridge
1.Cut nozzle to give the required angle and bead size
2.Pierce the membrane at the top of the cartridge and screw on the nozzle
3.Place the cartridge in an applicator gun and squeeze the trigger with equal strength
For sausage
1.Clip the end of the sausage and place in barrel gun
2.Screw end cap and nozzle on to barrel gun
3.Using the trigger extrude the sealant with equal strength
Attention of operation
Wear suitable protective clothing, gloves and eye/face Protection. After contact with skin, wash immediately with plenty of water and soap. In case of accident or if you feel unwell, seek medical advice immediately.
∎Packing and Storage
