Application:
This tester is used to determine the degree of flaking or cracking caused by winding.
brief introduction
This unit has two sample clips and can adjust the distance to the required length.Once the sample is fixed in position, the clamp can be compressed together to apply the required load to the sample, making the sample change 180 degrees under pressure. After the sample is compressed, the machine is turned on and the driver starts running.This allows the sample to slide back and forth to form the desired bending motion. The sliding distance is also adjustable, but should be set before the test begins. This machine has a self-stopping adjustable counter. When the test is over, remove the sample and check for damage to the sample.
testing standard：
Toyota TSL 5101G(section3.29)，Nissan NES M0155(section17)，TSL 5100G section 4.7，NES M7081 section 15.2（Sukotto Crumpling）
