Reasons to Purchase Our Signal Repeaters
Signal Repeater are very effective equipment that can offset the covering shortage of the base station of the mobile network, expand the cover range of the base station and fill the signal blind zone to ensure the convenient and pleasant communication. The only requirement signal repeater need for all this is at least middle range signal outside this area.
If you are in such a situation and thinking about your own repeater, please bare in mind that all our products have a huge list of advantages:
1) In our case more bars more calls. Signal booster provides the well-organized service that’s why after installation of the system the quality of the connection will be really great.
2) Signal Repeater require no additional wires being attached to your cell phone thus allowing you to use your cell phone without any extra troublesome accessories, in other worlds, no physical connection to your cell phone.
3) They are practical, beautiful, easy to install and with competitive price. You will not need to hire anybody to provide the installation of the equipment. You’ll be able to install it by yourself using only the manual list attached to your signal repeater.
4) Signal booster works at full duplex. It means that they are not only receiving the signal from the base mobile station but they also send the signal to the base mobile station.
5) Our equipment is completely safe. Signal booster don’t produce any radiation
6) Signal boosters are able to cover different coverage: from small to large. In this case you can decide which of signal repeater is suitable for your office or supermarket.
Key specifications
Working system GSM
Frequency range Uplink 890~915MHz Downlink 935~960MHz
Gain Uplink 20dB Downlink 23 dB
Pass band ripple ≤1.8DB
I/O impendence 50Ω/N connector
Noise figure ≤6dB
Transmission delay ≤0.5μs
Ambient temperature -15°C~55°C
Power supply AC110V-240V DC 12V
Size 198mm148mm39mm
Coverage area 300Sqm
Mobile signal repeater Installation
Step 1 Start by taking your phone up to the roof or other location outside to find where the signal is strongest.
Step 2 Temporarily mount the Outdoor (outside) antenna in that location. You may need to adjust and move the antenna later. More notes on Donor antennas here.
Step 3Run coaxial cable into the building to a convenient location (attic, etc.) where you can also get standard power for the Signal Repeater.
Step 4 Place the Signal Repeater in that location and connect the coaxial cable to the Outdoor Side of the Signal Repeater and the Outdoor antenna.
Step 5 Mount your Indoor (inside) antenna in a productive location. You may need to adjust or move the antenna later. More notes on Indoor antennas and patterns here.
Step 6Connect coaxial cable between the Indoor antenna and the Signal Repeater output port.
