Characteristics of the rigid polyurethane foam cutter:
- The rigid polyurethane foam cutting machine includes cutter adjusting wheels, which have good stiffness, especially suitable for cutting PU foam plastic with Shaw hardness below 80 and having a large supporting capacity and stable cutting properties . 2. Square steel work table with smooth surface and resistance structure adopted to be coupled with the rigid wheel case and to guarantee stability and precision in the cutting process. 3. The cutting tool employs a wide strip cutter. The cutter does not produce flying dust and ensures the smoothness and good parallelism of the cutting surface, without leaving traces of cut. 4. The operations of the polyurethane rigid foam cutter type belt cutter can be completed by program control, which has the advantage of accurately controlling the height of the cutter, easily configure the computer, have the function of photoelectric screen and have modes convenient operation of auto and manual.
Rigid polyurethane foam cutter
Structure and principle of operation:
The rigid polyurethane foam cutting machine consists of a cutter adjustment wheel, a cutter raising and lowering mechanism, a work table assembly and a computer control system, among others.
It works as follows: the cutting thickness and the lifting height of the cutter must be predefined, then the lifting and lowering mechanism of the cutter goes to the automatic working state and the work table transports foam to be cut by the cutter. strips on high-speed rotating wheels. Once the cut is completed, the computer will send a signal and the cutter will automatically rise to the pre-set height and the work table will return to the original place. At this time, the cutter, deducting the high height, will lower to the designated height and prepare for another cut.
Application of Hard Polyurethane Foam Cutter:
The machine is applicable for cutting into rigid slices (ie, for use on vehicle roofs, with tape cutter) or semi-rigid PU thermoplastic Products and rigid PU foam with thick coatings (ie insulating panel, with tooth cutter) Mountain range).
Main technical parameters:
Size of foam that can be cut (Length × Width × Height) mm 2000 × 1600 × 1200
3000 × 1600 × 1200
Dimension of the work table (Length × Width) 2500 × 1700 mm
3500 × 1700 mm
Line speed of the moving work table 0 ~ 10 m / min
Linear speed of the moving strip cutter approximately 14 m / s
Cutting thickness 3 mm ~ 10 mm
