Waterjet Cutting
A machine known as a waterjet cutter produces a high-pressure jet of water with entrained abrasive granules. When these are directed at a piece of metal, ceramic, or stone, a cutting action can occur that produces very little dust and cuts at a low temperature. Waterjet cutters are used in manufacturing and mining.
Abrasive Blasting
Garnet granules are also used in abrasive blasting (commonly known as "sand blasting"). In these processes, a tool propels a stream of abrasive granules (also known as "media") against a surface using a highly pressurized fluid (usually air or water) as a propellant. Abrasive blasting is done in order to smooth, clean, or remove oxidation products from metals, brick, stone, and other materials. It is usually much faster than sanding by hand or with a sanding machine. It can clean small and intricate surfaces that other cleaning methods would miss. Abrasives of various hardnesses can be used to clean a surface of greater hardness, without damaging the surface.
Filtration
Garnet granules are often used as a filter media. Small garnet particles are used to fill a container through which a liquid flows. The pore spaces of the garnet are small enough to allow passage of the liquid but are too small to allow passage of some contaminant particles, which are filtered from the flow. Garnet is suited for this use because it is relatively inert and has a relatively high specific gravity. Garnet granules, crushed and graded to about 0.3 millimeters in size, can be used to filter out contaminant particles as small as a few microns in diameter. Garnet's high specific gravity and high hardness reduce bed expansion and particle abrasion during backflushing.
